UbSvr Software RAID

[Chan Chung Hang Christopher]

> Partitioning: I created new partition tables and created my partitions.
> RAID configuration: was slightly different than the instructions, but
> seemed to work.
> Formatting: I could not follow these instructions.  It would not let me
> make changes to RAID1 device #0.
>
> Here is my current partition table:
> RAID1 device #0 - 131.5mb software RAID device
>                          #1   131.5mb      f      swap      swap
> SCSI2 (0,0,0) (sda) -  120.0 GB ATA ST3120827AS
>                          #1   primary   131.6   mb   k   raid
>                          #2   primary   58.9   gb   k   raid
>                          #3   primary   58.9   gb   k   raid
>                          #4   primary   2.0   gb   k   raid
> SCSI2 (0,1,0) (sdb) -  120.0 GB ATA ST3120827AS
>                          #1   primary   131.6   mb   k   raid
>                          #2   primary   58.9   gb   k   raid
>                          #3   primary   58.9   gb   k   raid
>                          #4   primary   2.0   gb   k   raid
>
> Can someone tell me where I am going wrong with this?  Any advice would
>   


Please post the output of 'sudo fdisk -l' and 'cat /proc/mdstat'