Intel 3945ABG Wirelss Issue on hardy

[Flavio Costa]

Using nm-applet seems the easiest way of doing it, but you can try issuing
this command: "iwlist <wireless-interface\> scanning"

On Wed, May 7, 2008 at 2:14 PM, Ankur Jain <ankurj at gmail.com> wrote:

> Hi
>
> I upgraded to Hardy from Gutsy on my Dell Inspiron 1520. Now the wireless
> router doesn't work at all. Though the wifi card is detected. Could someone
> guide me through.
>
> Output of "lspci | grep 3945 "
>
> 0
> c:00.0 Network controller: Intel Corporation PRO/Wireless 3945ABG Network
> Connection (rev 02)
>
> Output of iwconfig eth1 is given below :
>
> eth1      IEEE 802.11g  ESSID:""  Nickname:""
>           Mode:Managed  Frequency:2.462 GHz  Access Point:
> 00:1E:E5:69:8B:85
>           Tx-Power=27 dBm
>           Retry min limit:7   RTS thr:off   Fragment thr=2346 B
>           Encryption key:off
>           Power Management:off
>           Link Quality:0  Signal level:0  Noise level:0
>           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
>
> Output of lshw -C network is
>   *-network
>        description: Wireless interface
>        product: PRO/Wireless 3945ABG Network Connection
>        vendor: Intel Corporation
>        physical id: 0
>        bus info: pci at 0000:0c:00.0
>        logical name: wmaster0
>        version: 02
>        serial: 00:1b:77:81:0d:30
>        width: 32 bits
>        clock: 33MHz
>        capabilities: pm msi pciexpress bus_master cap_list logical
> ethernet physical wireless
>        configuration: broadcast=yes driver=iwl3945 latency=0
> module=iwl3945 multicast=yes wireless=IEEE 802.11g
>   *-network
>        description: Ethernet interface
>        product: BCM4401-B0 100Base-TX
>        vendor: Broadcom Corporation
>        physical id: 0
>        bus info: pci at 0000:03:00.0
>        logical name: eth0
>        version: 02
>        serial: 00:19:b9:85:5e:ec
>        size: 100MB/s
>        capacity: 100MB/s
>        width: 32 bits
>        clock: 33MHz
>        capabilities: pm bus_master cap_list ethernet physical mii 10bt
> 10bt-fd 100bt 100bt-fd autonegotiation
>        configuration: autonegotiation=on broadcast=yes driver=b44
> driverversion=2.0 duplex=full ip=192.168.1.100 latency=64 link=yes
> module=ssb multicast=yes port=twisted pair speed=100MB/s
>
>
> Could someone help me connect to my wifi network (Open, unrestricted as of
> now)
>
> --
> Regards
> Ankur Jain
>
> http://ankurjain.org
> --
> ubuntu-users mailing list
> ubuntu-users at lists.ubuntu.com
> Modify settings or unsubscribe at:
> https://lists.ubuntu.com/mailman/listinfo/ubuntu-users
>
>


-- 
Flávio Coutinho da Costa
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.ubuntu.com/archives/ubuntu-users/attachments/20080507/6f2c6bc7/attachment.html>