Files from camcorder to folder

[Norman Silverstone]

> > Thanks, tried your suggestion but no USB drive shown unmounted or
> > otherwise.
> >
> 
> The next thing I would try is to open a terminal window, type:
> 
> tail -f /var/log/syslog
> 
> And then connect the camera again and see what, if anything, is
> displayed. That'll tell you, for example, if there is any signal at
> all at the computer end and might display a helpful error message or
> two.

After opening terminal and typing as indicated the camcorder was
switched on, the USB cable connected and pressed enter.  The camcorder
was then switched off. Result as follows:-

norman at gruber:~ $ tail -f /var/log/syslog
Oct 13 13:41:12 localhost kernel: [17675736.024000] usb 1-2.1: 400mA
over 100mA budget!
Oct 13 13:41:12 localhost kernel: [17675736.024000] hub 1-2:1.0: 102mA
over power budget!
Oct 13 13:42:04 localhost kernel: [17675787.680000] usb 1-2.4: USB
disconnect, address 17
Oct 13 13:46:42 localhost kernel: [17676066.472000] usb 1-2.4: new full
speed USB device using uhci_hcd and address 18
Oct 13 13:46:43 localhost kernel: [17676066.572000] usb 1-2.1: 400mA
over 100mA budget!
Oct 13 13:46:43 localhost kernel: [17676066.572000] hub 1-2:1.0: 102mA
over power budget!
Oct 13 13:47:53 localhost kernel: [17676137.040000] usb 1-2.4: USB
disconnect, address 18
Oct 13 13:50:33 localhost kernel: [17676296.692000] usb 1-2.4: new full
speed USB device using uhci_hcd and address 19
Oct 13 13:50:33 localhost kernel: [17676296.788000] usb 1-2.1: 400mA
over 100mA budget!
Oct 13 13:50:33 localhost kernel: [17676296.788000] hub 1-2:1.0: 102mA
over power budget!
Oct 13 13:51:29 localhost kernel: [17676352.544000] usb 1-2.4: USB
disconnect, address 19

What does this mean please?

Norman