dapper drake install

[dave s]

On Sunday 05 Mar 2006 17:34, Carl Karsten wrote:
> Marek Pawinski wrote:
> > dave s wrote:
> >> On Sunday 05 Mar 2006 13:26, Marek Pawinski wrote:
> >>> dave s wrote:
> >>>> Hi all,
> >>>>
> >>>> On my new computer I thought I would do a fresh install of dapper
> >>>> drake.
> >>>> I downloaded cd 4 flight. I must say the install has been jazzed up
> >>>> and looks good :)
> >>>>
> >>>> Anyhow I needed raid so I got to the part where you partition the
> >>>> disks,
> >>>> did that and then discovered there is no <continue> button on the
> >>>> partitioner, did a <back> the installer moved me on to 'set timezone'
> >>>> I selected it but it takes me back to partitioning. I cannot get past
> >>>> partitioning no matter what I try.
> >>>>
> >>>> Any ideas
> >>>>
> >>>> Dave
> >>>
> >>> Did you scroll down with the arrow key ?
> >>
> >> Sure did, I looked everywhere,  I pressed the finish partitioning &
> >> write to disk button, zip, so I had to press <back>
> >>
> >> Dave
> >
> > That's odd i did the same and it went further, try see if there are any
> > messages in the consoles if you have not done that already, otherwise i
> > am stumpted. Normally gives an error message if the partioning is
> > incorrect.
>
> I have seen this too.  I think it is due to something like no partition
> selected for / or / not marked to be formated.  I am very sure I was able
> to get past just by selecting partitioning options, not going back to
> timezone or the menu
>
> Carl K

At least its not just me :)

Well I have spent a good few hours playing with it and am officialy stuck. 
Anyone else had this problem, any workarounds ?

Dave