Dapper chokes on printing graphics

[Florian Diesch]

Dave M G <martin at autotelic.com> wrote:

> Then I tried to print a test page. I was thrilled to see it start
> printing. And then depressed to see it stop printing... half way
> through the page.
>
> I waited to see if eventually the page would finish, but after a
> quarter of an hour I figured it had stalled. So I reset the printer,
> turned it off and on and waited a bit, then tried another test
> page. It halted in the exact same place. Just a little less than
> exactly half way.

In /etc/cups/cupsd.conf set "LogLevel" to "debug" and have a look at the
logfile when printing ("sudo tail -f /var/log/cups/error_log" in a
terminal window). What does it say?


   Florian
-- 
<http://www.florian-diesch.de/>