Re: Matrox harddisk doesn´t show
Thomas Beckett
thomas.beckett at gmail.com
Thu Feb 10 16:13:36 UTC 2005
On Thu, 10 Feb 2005 16:45:55 +0100, Vincent Trouilliez
<vincent.trouilliez at modulonet.fr> wrote:
> > Running the installation on CD. Ubundu makes it´s own file system and
> > all seems to be okey. After rebooting ubuntu doesn't find a harddrive?
> >
> > It does not appear on the BIOS list when computer boots.
>
> Bad luck :-/
>
> If the BIOS doesn't find the drive then Ubuntu is unlikely to be at
> fault.
>
> Everytime I saw this random hard drive detection problem, the cause were
> usually :
>
> 1) Wrong Jumper setting, or missing jumper.
> 2) Cable not plugged firmly/properly into place
> 3) Defective ribbon cable
> 4) Damaged motherboard, when the assembler/operator secures the board
> into the chassis with pneumatic screwdriver. Usually obvious to see, but
> sometimes requires a magnifying lens to inspect the tracks.
> 5) Defective motherboard (rare)
>
> Sometime the hardrive itself is defective, but these are rejected during
> production. I find it unlikely that a good/working drive develops the
> problem, unless it got damaged by the user (which is possible as, sadly,
> most drives now have their PCB exposed :-/ )
>
> Check jumper settings, check that the cable is plugged firmly.
> Unplug all your other peripherals and set your hard drive as sinlge
> master. Connect the cable to the other IDE controller (they are
> independant, sometimes one work, not the other). Swap the cable. Check
> that the IDE controller the drive is connected to, can detect other
> peripherals, or if it's just the drive that it can't detect.
>
> Hopefully it's something simple. (usually is)
>
> Vince
>
>
> --
> ubuntu-users mailing list
> ubuntu-users at lists.ubuntu.com
> http://lists.ubuntu.com/mailman/listinfo/ubuntu-users
>
Also Id try going into your bios settings (F12, F10, whatever key your
bios uses upon booting) and running the disk detection part. some
motherboards (older ones?) dont detect new hard disks at each boot,
you may need to select auto for the ide channel that the disk is in.
I would tend to agree with vince though, if its not showing up on the
bios' POST then you likely have the jumpers set wrong - either both
drives on that ribon set to slave or both to master.
Also, you didnt mention if it is IDE or not, im guessing it is, but if
you are trying to set up SCSI disks or SATA disks then its a whole
different kettle of fish that Ive never swum (this a word?) in!
Tom
--
Q: How many freudians does it take to change a lightbulb?
A: Two - one to change the bulb - the other to hold the penis...
.... I mean ladder!!!
More information about the ubuntu-users
mailing list