IBM x40 suspend/resume

[christophe barbe]

After following Daniel Stone instructions
   http://people.ubuntu.com/~daniels/x40/ 
I have got suspend/resume working properly (as long as I don't
change the power mode during its sleep, ac vs. battery).

The only problem is that I get a beep during the resume. I disabled every
beep I could in the bios settings and still get the beep (only while
resuming). I don't know who is causing it but it is rather annoying when
you resume your laptop in public. The beep volume is only afftected by
the hardware volume (ie. the small volume buttons) but not by the alsa
volume. In the log I see no hint:

Back to C!
cpufreq: resume failed to assert current frequency is what timing core
thinks it is. PM: Finishing up.
PCI: Setting latency timer of device 0000:00:1d.0 to 64
PCI: Setting latency timer of device 0000:00:1d.0 to 64
PCI: Setting latency timer of device 0000:00:1d.1 to 64
PCI: Setting latency timer of device 0000:00:1d.1 to 64
PCI: Setting latency timer of device 0000:00:1d.2 to 64
PCI: Setting latency timer of device 0000:00:1d.2 to 64
ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 193
PCI: Setting latency timer of device 0000:00:1d.7 to 64 ACPI: PCI
interrupt 0000:00:1f.1[A] -> GSI 18 (level, low) -> IRQ 185
ACPI: PCI interrupt 0000:00:1f.5[B] -> GSI 17 (level, low) -> IRQ 201
PCI: Setting latency timer of device 0000:00:1f.5 to 64 ACPI: PCI
interrupt 0000:00:1f.6[B] -> GSI 17 (level, low) -> IRQ 201
PCI: Setting latency timer of device 0000:00:1f.6 to 64 eth1: Coming out of suspend...
Restarting tasks... done
ACPI: Power Button (FF) [PWRF] ACPI: Lid Switch [LID]
ACPI: Sleep Button (CM) [SLPB]
ACPI: PCI interrupt 0000:00:1d.7[D] -> GSI 23 (level, low) -> IRQ 193
ehci_hcd 0000:00:1d.7: Intel Corp. 82801DB (ICH4) USB2 EHCI Controller
PCI: Setting latency timer of device 0000:00:1d.7 to 64
ehci_hcd 0000:00:1d.7: irq 193, pci mem f0754000
ehci_hcd 0000:00:1d.7: new USB bus registered, assigned bus number 4
PCI: cache line size of 32 is not supported by device 0000:00:1d.7
ehci_hcd 0000:00:1d.7: USB 2.0 enabled, EHCI 1.00, driver 2004-May-10

Interestingly the beep occurs not right at the beginning but rather
while switching back to X. I try to play with the resume.sh script
without success.

Any ideas ?

Thanks,
Christophe

-- 
Christophe Barbé <christophe.barbe at ufies.org>
GnuPG FingerPrint: E0F6 FADF 2A5C F072 6AF8  F67A 8F45 2F1E D72C B41E

An empty stomach is not a good political advisor.
-- Albert Einstein