Error: says IEEE80211_CRYPT_WEP symbol undefined

[Bryan Pizzuti]

This gets better.  That IEEE80211_CRYPT_WEP symbol that it says is
undefined....well, I just FOUND the correct modules and sources
in /usr/src/linux-source-2.6.8.1/drivers/net/wireless/ieee80211

ieee80211_crypt_wep.c
ieee80211_crypt_wep.ko
ieee80211_crypt_wep.o

(Also available in .mod.c .mod.ko and .mod.o flavors)

SO will someone PLEASE tell me what's going ON with this KERNEL
SOURCE???  I've posted a couple of times on this and no one has
answered.

On Fri, 2004-11-19 at 08:10 -0500, Bryan Pizzuti wrote:
> Ok, I figured out part of this...I need to add in the hostap and
> hostap_crypt_wep modules out of the HostAP driver page.  No problem,
> I've got them.  Where am I supposed to put them? Obviously somewhere in
> the /usr/src/linux-sounce-2.6.8.1 directory, but that only narrows it
> down so much. 
> 
> On Thu, 2004-11-18 at 08:50 -0500, Bryan Pizzuti wrote:
> > Doesn't matter which one I run, I get an error when I run it to try to
> > configure the kernel sources downloaded from the Ubuntu Warty
> > repository.  This is the error:
> > 
> > drivers/net/wireless/Kconfig:303:warning: 'select' used by config symbol
> > 'IPW2200' refer to undefined symbol 'IEEE80211_CRYPT_WEP'
> > 
> > Can anyone duplicate it? This is driving me NUTS! I want to custom-roll
> > a kernel with the CPUFREQ interface installed (so I can use CPUFREQD)
> > and with software-suspend support enabled!
> > 
> > 
> > 
> 
>