<div dir="ltr"><div><div><div><div><div><div><div><div><div><div>I have being trying to get my 5 year old Mecer machine going again (it has been sitting gathering dust for a few months). But I seem to go back two steps for every one forward.<br>
<br></div><div>This machine used to run 10.04 with no problems. I had two hard disks  - a 160 GB drive (sdb) which I had partitioned sdb1 = root, sdb2 = swap and sdb3 = home. Then a 500 GB drive (sda) that I used as backup storage.<br>
</div><div><br></div>I started off trying to install Ubuntu 12.10 because that is a disk that I had easily available.  It ran beautifully in live mode.<br><br>The installation took forever - it seemed to get stuck downloading updates to my existing packages. So I repeated the installation without connecting to the Internet. <br>
<br>Again the installation seemed to go fine, but the machine booted to the point of asking for my password - it then refused to accept my password and would not go any further. OK so perhaps I mistyped my password or had a senior moment or something, so I re-installed. Same thing.<br>
<br></div>Hm. So I repeated the installation except this time I told it to format sdb1. Things went better and the machine accepted my password this time. In fact everything looked good and I thought that I had a working Ubuntu system. So I thought it was time to install all the updates that were missing. That took a few hours.<br>
<br></div>But now I had a new problem. The Unity GUI kept on just vanishing - the icons on the left and the tool bar on the top just vanished leaving me a completely useless machine. Sure, I could get a terminal window by CTl-ALT-T, but the terminal would not accept anything that I typed. I had to push the power button to shut the machine down and when I started it up again, the GUI vanished within seconds of my logging in.<br>
<br></div>I decided to cut my losses and start again. So I downloaded Xubuntu 13.04 and tried it in live mode. It worked perfectly - I was particularly impressed that it found my wireless card and used it without problems whereas previously I had had to compile the driver. I installed and the installation went through. But on booting, I got the message " <br>
<br>no such device d42bef6d ....<br></div>grub-rescue><br><br></div>This is the point at which I am still stuck. I have Googled this and followed instructions to restore Grub, but get a variety of error messages depending on the sequence that I follow. I have tried telling the installer to forget the existing partitions on sdb and to use the whole drive - no change. I still get the "no such device" message.<br>
<br></div>I am tearing my hair. How can a new installation not be able to find Grub?<br><br></div>I am beginning to assume that I must have a hardware error. Any suggestions?<br><br></div>Thanks,<br></div>  Bill<br><div><div>
<div><div><div><div><div><br><div><div><div><br></div></div></div></div></div></div></div></div></div></div></div>