Flash drives fails automount on Jammy

[MR ZenWiz]

On Mon, Aug 12, 2024 at 8:41 AM Colin Law <clanlaw at gmail.com> wrote:
>
:
>
> What are sdc and sdd?
These are both hard drives directly mounted from fstab - I seriously
doubt they have anything to do with this.

I did notice that there's this TONPHA device that shows up when any
USB drive is plugged in. I don't recognize that and I wonder what it
is and how it got there. Rootkit maybe? It did not show up this time
at all - highly suspicious to me...

> Assuming those are not the flash drives then reboot without them plugged in, run
> tail -f /var/log/syslog
> and plug one of them in.  Show us what you see.
>
I did not reboot, just grabbed the latest from syslog (after plugging
the drive in):

Aug 12 09:12:16 marbase kernel: [ 5462.532162] usb 1-5: new high-speed
USB device number 9 using xhci_hcd
Aug 12 09:12:17 marbase kernel: [ 5462.684710] usb 1-5: New USB device
found, idVendor=0781, idProduct=5591, bcdDevice= 1.00
Aug 12 09:12:17 marbase kernel: [ 5462.684719] usb 1-5: New USB device
strings: Mfr=1, Product=2, SerialNumber=3
Aug 12 09:12:17 marbase kernel: [ 5462.684723] usb 1-5: Product:
SanDisk 3.2Gen1
Aug 12 09:12:17 marbase kernel: [ 5462.684726] usb 1-5: Manufacturer:  USB
Aug 12 09:12:17 marbase kernel: [ 5462.684729] usb 1-5: SerialNumber:
0401793e63c16a9a1ec7dba4578db70eb254da20378228dccfdbaf0761ad4aabf73200000000000000000000ee5ec4210080b11891558107a92846c8
Aug 12 09:12:17 marbase kernel: [ 5462.685867] usb-storage 1-5:1.0:
USB Mass Storage device detected
Aug 12 09:12:17 marbase kernel: [ 5462.686170] scsi host8: usb-storage 1-5:1.0
Aug 12 09:12:17 marbase mtp-probe: checking bus 1, device 9:
"/sys/devices/pci0000:00/0000:00:01.2/0000:01:00.0/0000:02:08.0/0000:06:00.1/usb1/1-5"
Aug 12 09:12:17 marbase mtp-probe: bus: 1, device: 9 was not an MTP device
Aug 12 09:12:17 marbase mtp-probe: checking bus 1, device 9:
"/sys/devices/pci0000:00/0000:00:01.2/0000:01:00.0/0000:02:08.0/0000:06:00.1/usb1/1-5"
Aug 12 09:12:17 marbase mtp-probe: bus: 1, device: 9 was not an MTP device
Aug 12 09:12:17 marbase colord-sane: io/hpmud/musb.c 2099: Invalid
usb_open: Permission denied
Aug 12 09:12:17 marbase colord-sane: message repeated 6 times: [
io/hpmud/musb.c 2099: Invalid usb_open: Permission denied]
Aug 12 09:12:17 marbase gvfs-udisks2-vo[2436]: monitor says it's not supported
Aug 12 09:12:18 marbase kernel: [ 5463.713943] scsi 8:0:0:0:
Direct-Access      USB      SanDisk 3.2Gen1 1.00 PQ: 0 ANSI: 6
Aug 12 09:12:18 marbase kernel: [ 5463.714522] sd 8:0:0:0: Attached
scsi generic sg6 type 0
Aug 12 09:12:18 marbase kernel: [ 5463.714910] sd 8:0:0:0: [sde]
60088320 512-byte logical blocks: (30.8 GB/28.7 GiB)
Aug 12 09:12:18 marbase kernel: [ 5463.715399] sd 8:0:0:0: [sde] Write
Protect is off
Aug 12 09:12:18 marbase kernel: [ 5463.715403] sd 8:0:0:0: [sde] Mode
Sense: 43 00 00 00
Aug 12 09:12:18 marbase kernel: [ 5463.715889] sd 8:0:0:0: [sde] Write
cache: disabled, read cache: enabled, doesn't support DPO or FUA
Aug 12 09:12:18 marbase kernel: [ 5463.724073]  sde: sde1
Aug 12 09:12:18 marbase kernel: [ 5463.724207] sd 8:0:0:0: [sde]
Attached SCSI removable disk
Aug 12 09:12:17 marbase gvfs-udisks2-vo[2436]: monitor says it's not supported
Aug 12 09:12:18 marbase colord-sane: io/hpmud/musb.c 2099: Invalid
usb_open: Permission denied
Aug 12 09:12:18 marbase colord-sane: message repeated 6 times: [
io/hpmud/musb.c 2099: Invalid usb_open: Permission denied]
Aug 12 09:12:18 marbase gvfs-udisks2-vo[2436]: monitor says it's not supported
Aug 12 09:12:18 marbase gvfs-udisks2-vo[2436]: monitor says it's not supported
Aug 12 09:12:24 marbase wpa_supplicant[1227]: wlp4s0: CTRL-EVENT-BEACON-LOSS

Why is the monitor rejecting the drive?