using kismet in Ubuntu

[Bond]

On Thu, Jan 20, 2011 at 2:45 PM, Bond <jamesbond.2k.g at gmail.com> wrote:
> I installed kismet on my system as
> aptitude install kismet.
> But when I run kismet I do not find any ncurses sort of interface as I
> expect give here
> http://openmaniak.com/kismet_conf.php
>
> and this is the error I get
>
> kismet
> Launching kismet_server: //usr/bin/kismet_server
> Suid priv-dropping disabled.  This may not be secure.
> No specific sources given to be enabled, all will be enabled.
> Non-RFMon VAPs will be destroyed on multi-vap interfaces (ie, madwifi-ng)
> Enabling channel hopping.
> Enabling channel splitting.
> NOTICE: Disabling channel hopping, no enabled sources are able to
> change channel.
> Source 0 (addme): Opening none source interface none...
> FATAL: Please configure at least one packet source.  Kismet will not
> function if no packet sources are defined in kismet.conf or on the
> command line.  Please read the README for more information about
> configuring Kismet.
> Kismet exiting.
> Done.
>
> So what could be the problem?
>
I wanted to update more on this problem

I followed this guide
http://www.ubuntugeek.com/kismet-an-802-11-wireless-network-detector-sniffer-and-intrusion-detection-system.html#more-1776

how ever in kismet.conf I am not clear with following line

source=none,none,addme

as to what should I change this to.

lspci -vnn shows

0c:00.0 Network controller [0280]: Broadcom Corporation BCM4312
802.11b/g [14e4:4315] (rev 01)
Subsystem: Dell Device [1028:000c]
Flags: bus master, fast devsel, latency 0, IRQ 17
Memory at f69fc000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Capabilities: [58] Vendor Specific Information <?>
Capabilities: [e8] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
Capabilities: [d0] Express Endpoint, MSI 00
Capabilities: [100] Advanced Error Reporting <?>
Capabilities: [13c] Virtual Channel <?>
Capabilities: [160] Device Serial Number
Capabilities: [16c] Power Budgeting <?>
Kernel driver in use: wl
Kernel modules: wl, ssb

and

iwconfig shows


lo no wireless extensions.

eth0 no wireless extensions.

eth1 IEEE 802.11bg ESSID:"WIKUCD"
Mode:Managed Frequency:2.462 GHz Access Point: <00:43:92:21:H5:09>
Bit Rate=11 Mb/s Tx-Power:24 dBm
Retry min limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Managementmode:All packets received
Link Quality=1/5 Signal level=-81 dBm Noise level=-90 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:169 Invalid misc:0 Missed beacon:0

So what should I be putting in place of
source=none,none,addme
with output I mentioned above ?