setting up HP 4050 with network adapter

[Chris Mohler]

On Fri, Feb 13, 2009 at 6:46 PM, Wade Smart <wade at wadesmart.com> wrote:

> wadesmart at wadesmart:~$ telnet 192.168.1.80
> Trying 192.168.1.80...
> Connected to 192.168.1.80.
> Escape character is '^]'.
>
> HP JetDirect
>
> Please type "?" for HELP, or "/" for current settings
>  > /
>
>    ===JetDirect Telnet Configuration===
>        Firmware Rev.   : G.08.49
>        MAC Address     : 08:00:09:6e:f7:6b
>        Config By       : USER SPECIFIED
>
>        IP Address      : 192.168.1.80
>        Subnet Mask     : 255.255.255.0
>        Default Gateway : 192.168.1.1
>        Syslog Server   : 192.168.1.82
>        Idle Timeout    : 90 Seconds
>        Set Cmnty Name  : Not Specified
>        Host Name       : PAL5U006
>        Default Get Cmnty : Enabled
>
>        DHCP Config     : Disabled
>        Passwd          : Disabled
>        IPX/SPX         : Enabled
>        DLC/LLC         : Disabled
>        Ethertalk       : Disabled
>        Banner page     : Enabled
>  >
>
> Yes, I can connect.

Good.  How about the CUPS config and/or netcat?  I only mention the
netcat test because I had to do some esoteric stuff in the past with
LaserJet 4MV (that was on a localtalk/ethernet bridge) and I needed to
bypass CUPS to make sure the printer was available and accepting
postscript (before I went nutty trying to mess w/the pap backend)...

Chris