Problem with 'Realtek RTL-8169 Gigabit Ethernet (rev 10)' on ibex

[Ben Edwards]

Sorry, I got the revision wrong, it should of been (rev 10).

Regards,
Ben

2008/12/8 Ben Edwards <list4me2 at googlemail.com>:
> I have the following Ethernet Cards:-
>  01:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd.
> RTL-8169 Gigabit Ethernet (rev 08)
>  01:08.0 Ethernet controller: Intel Corporation 82562EZ 10/100
> Ethernet Controller (rev 02)
>
> The Intel one is the on board one.  The problem is I cant get the
> Gigabit one working.
>
> Ifconfig gives me:
>
> eth1    Link encap:Ethernet  HWaddr 00:0d:61:50:f1:21
>          inet addr:192.168.1.95  Bcast:192.168.1.255  Mask:255.255.255.0
>          inet6 addr: fe80::20d:61ff:fe50:f121/64 Scope:Link
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:963 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:611 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:148483 (148.4 KB)  TX bytes:66393 (66.3 KB)
>
> lo        Link encap:Local Loopback
>          inet addr:127.0.0.1  Mask:255.0.0.0
>          inet6 addr: ::1/128 Scope:Host
>          UP LOOPBACK RUNNING  MTU:16436  Metric:1
>          RX packets:313 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:313 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:0
>          RX bytes:479099 (479.0 KB)  TX bytes:479099 (479.0 KB)
>
> and  'dmesg | grep eth' gives me:-
> [    4.293137] e100: eth0: e100_probe: addr 0xf7003000, irq 20, MAC
> addr 00:0d:61:50:f1:21
> [    4.345633] Driver 'sd' needs updating - please use bus_type methods
> [   15.324269] udev: renamed network interface eth0 to eth1
> [   22.101136] e100: eth1: e100_watchdog: link up, 100Mbps, full-duplex
> [   33.384021] eth1: no IPv6 routers present
>
> Any ideas?
>
> Reghards,
> Ben
>