Maxtor Mini External Hard Drive
corbtr at hotmail.com
Sat Apr 12 01:25:50 UTC 2008
Tried "dmesg" and there is plenty of ref to the usb maxtor
so i guess its sorta being detected any further thoughts ?
[ 22.630307] usb usb4: configuration #1 chosen from 1 choice
[ 22.630342] hub 4-0:1.0: USB hub found
[ 23.769697] Initializing USB Mass Storage driver...
[ 23.769818] scsi0 : SCSI emulation for USB Mass Storage devices
[ 23.769885] usbcore: registered new interface driver usb-storage
[ 23.769889] USB Mass Storage support registered.
[ 23.770000] usb-storage: device found at 2
[ 23.770002] usb-storage: waiting for device to settle before scanning
[ 23.818873] ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
[ 23.825366] Probing IDE interface ide1...
[ 24.685777] hdc: HL-DT-ST DVDRAM GSA-H42N, ATAPI CD/DVD-ROM drive
[ 25.022467] ide1 at 0x170-0x177,0x376 on irq 15
[ 25.035944] hda: max request size: 512KiB
[ 25.047613] hda: 78242976 sectors (40060 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
[ 25.047839] hda: cache flushes supported
[ 25.047898] hda: hda1 hda2 < hda5 >
[ 25.088136] hdc: ATAPI 48X DVD-ROM DVD-R-RAM CD-R/RW drive, 2048kB Cache, UDMA(66)
[ 25.088148] Uniform CD-ROM driver Revision: 3.20
[ 25.293424] Attempting manual resume
[ 25.293430] swsusp: Resume From Partition 3:5
[ 25.293432] PM: Checking swsusp image.
[ 25.293612] PM: Resume from disk failed.
[ 25.309864] EXT3-fs: INFO: recovery required on readonly filesystem.
[ 25.309870] EXT3-fs: write access will be enabled during recovery.
[ 28.732933] kjournald starting. Commit interval 5 seconds
[ 28.732958] EXT3-fs: recovery complete.
[ 28.733189] EXT3-fs: mounted filesystem with ordered data mode.
[ 28.761083] usb-storage: device scan complete
[ 29.506787] scsi 0:0:0:0: Direct-Access Maxtor OneTouch III 0364 PQ: 0 ANSI: 4
[ 37.494918] eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
[ 38.724214] NET: Registered protocol family 17
[ 39.469452] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[ 39.540104] agpgart: Detected VIA KM400/KM400A chipset
[ 39.548116] agpgart: AGP aperture is 128M @ 0xd0000000
[ 40.651521] Additional sense: Invalid command operation code
[ 40.653914] SCSI device sda: 195371568 512-byte hdwr sectors (100030 MB)
[ 40.658709] sda: test WP failed, assume Write Enabled
[ 40.658715] sda: assuming drive cache: write through[ 40.665008] Additional sense: Invalid command operation code
[ 40.665500] SCSI device sda: 195371568 512-byte hdwr sectors (100030 MB)USB Mass Storage devices
[ 2106.014557] usb-storage: device found at 3
[ 2106.014559] usb-storage: waiting for device to settle before scanning
[ 2111.012214] usb-storage: device scan complete
[ 2111.778253] scsi 1:0:0:0: Direct-Access Maxtor OneTouch III 0364 PQ: 0 ANSI: 4
[ 2111.811409] sda: Unit Not Ready, sense:
[ 2623.639096] usb 4-2: USB disconnect, address 3
[ 2634.634261] usb 4-2: new high speed USB device using ehci_hcd and address 4
[ 2634.782338] usb 4-2: configuration #1 chosen from 1 choice
[ 2634.782599] scsi2 : SCSI emulation for USB Mass Storage devices
[ 2634.782761] usb-storage: device found at 4
[ 2634.782763] usb-storage: waiting for device to settle before scanning
[ 2639.776429] usb-storage: device scan complete
[ 2640.543227] scsi 2:0:0:0: Direct-Access Maxtor OneTouch III 0364 PQ: 0 ANSI: 4
[ 2640.576495] sda: Unit Not Ready, sense:
[ 2640.576503] : Current: sense key: Illegal Request
[ 2640.576506] Additional sense: Invalid command operation code
[ 2640.577205] SCSI device sda: 195371568 512-byte hdwr sectors (100030 MB)
> Date: Thu, 10 Apr 2008 10:43:40 -0400
> From: corey at 31415926535.com
> To: ubuntu-users at lists.ubuntu.com
> Subject: Re: Maxtor Mini External Hard Drive
> Tony Corbett wrote:
> > yep , its usb, and definately plugged in
> > and not showing in PLACES
> >> Corey Bettenhausen wrote:
> >>> Tony Corbett wrote:
> >>>> Hi, I have just loaded Ubuntu 7.04 to give it a go and need to figure out how to get my EHD connected.
> >>>> I have previously reloaded Windows NT I have had to download software for the EHD from the Seagate / Maxtor tech support site. This site makes no referecne ot reqyiuirmeents for linux etc.
> >>>> I have a Maxtor One touch III Mini ehd.
> >>>> Any help would be great. Keep it simple - im new to U.
> >>>> Cheers Tony
> >>> I'm not familiar with the particular drive that you mention, but I'll
> >>> assume it's a USB or firewire drive? If so, have you just tried to plug
> >>> it in?
> >>> -Corey
> >> Further, Windows NT didn't natively support USB. That's why you had to
> >> install software from Maxtor to get it to work. Ubuntu does support
> >> USB. So you should be able to just plug it in and it should show up on
> >> your desktop or through "Places" in the menu bar at the top of your screen.
> >> Cheers,
> >> -Corey
> Has the drive been formatted yet?
> To see if the drive has been detected at all, open a terminal window
> (Applications -> Accessories -> Terminal), plug in the drive, and type
> "dmesg" (without quotes) in the terminal window. If the drive is being
> detected, you should see some lines indicating that a new USB device has
> been attached.
> ubuntu-users mailing list
> ubuntu-users at lists.ubuntu.com
> Modify settings or unsubscribe at: https://lists.ubuntu.com/mailman/listinfo/ubuntu-users
Are you paid what you're worth? Find out: SEEK Salary Centre
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the ubuntu-users