How to see the driver my Wireless Interface card is using...

[Fawad Nazir]

Hi All,

I plugged in my Senao NL-2511CD PLUS Ext2 PCMCIA card and it works.
Its a prism chipset so it was supposed to only work with host AP
drivers. Looking at lsmod i could not find hostap driver loaded as
kernel module. I have actually no idea how my card is working.
I would like to know which driver/kernel-module my wireless adapter
card is using. I would also like to know that once i have installed
Host-AP driver, how can i make my card to use this new driver.

output of dmesg is:
[4299704.688000] eth2: Hardware identity 800c:0000:0001:0000
[4299704.689000] eth2: Station identity  001f:0000:0001:0008
[4299704.689000] eth2: Firmware determined as Intersil 1.8.0
[4299704.689000] eth2: Ad-hoc demo mode supported
[4299704.689000] eth2: IEEE standard IBSS ad-hoc mode supported
[4299704.689000] eth2: WEP supported, 104-bit key
[4299704.689000] eth2: MAC address 00:02:6F:39:B9:57
[4299704.689000] eth2: Station name "Prism  I"
[4299704.690000] eth2: ready
[4299704.698000] eth2: index 0x01: Vcc 3.3, irq 3, io 0x0100-0x013f
[4303504.380000] eth2: no IPv6 routers present


I will be thankful...

Regards,
-- 
Fawad Nazir