[Dapper] via-rhine driver for eth0

[Senectus .]

Since I upgraded my Desktop at home to Dapper My NIC has been b0rked :-P

It loads up what appears to be the correct module for it ( via-rhine
), but doesn't seem to attach to eth0.
If I do an ifconfig I only get lo
If I do an ifconfig -a I get :

eth0_clas Link encap:Ethernet  HWaddr 00:13:D4:C4:51:B4
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:217 Base address:0xd800

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:4818 errors:0 dropped:0 overruns:0 frame:
          TX packets:4818 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:478160 (466.9 KiB)  TX bytes:478160 (466.9 KiB)

sit0      Link encap:IPv6-in-IPv4
          NOARP  MTU:1480  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)

Since then I've downloaded the DVD version of Dapper and upgraded the
kernel to the K7
version with the restricted as well but to the same result.
Any idea's on where I go now?

--
www.modmeup.net
Ubuntu Breezy 5.10
The less you know, the more you believe. - Bono