Hoary on IBM X40 Network configuration
Erik Bågfors
zindar at gmail.com
Fri May 27 08:29:15 UTC 2005
Don't know how to do it the GUI way, but....
If you go to /etc/network/interfaces. You should see two lines saying
"auto eth0" and "auth eth1". If you remove them (or better yes, put #
infront of them), it will not autostart the interface.
/Erik
On 5/27/05, Tony <tony.kruse at gmail.com> wrote:
> I use my X40 laptop at several locations, some wireless, some Ethernet
> and various configurations.
>
> When I boot the laptop it must always go through and attempt to find a
> network or time out. I would like to leave the various configurations
> in place, however not to auto-activate on boot. I don't see how to do
> this with the Network Settings GUI that comes on Hoary.
>
> If I uncheck "This device is configured" under Properties, will this
> delete the configuration or just deactivate it?
>
> I don't want to delete any configurations, only set them not to
> auto-activate on boot.
>
> Thanks,
> Tony
>
> --
> ubuntu-users mailing list
> ubuntu-users at lists.ubuntu.com
> http://lists.ubuntu.com/mailman/listinfo/ubuntu-users
>
More information about the ubuntu-users
mailing list