Problems with Capture Card -- xawtv, tvtime, etc

[Stephen More]

I can go into my "Multimedia Systems Selector" and choose v4l....
When I do a test I can see the tv screen.

When I try to start xawtv all I get is a black screen, but I can hear the audio.

root at ubuntu:~ # xawtv -C /dev/vbi0 -c /dev/video0
This is xawtv-3.94, running on Linux/i686 (2.6.10-5-386)
WARNING: v4l-conf is compiled without DGA support.
WARNING: couldn't find framebuffer base address, try manual
         configuration ("v4l-conf -a <addr>")
Warning: Cannot convert string
"-*-ledfixed-medium-r-*--39-*-*-*-c-*-*-*" to type FontStruct
ioctl: VIDIOC_OVERLAY(int=1): Invalid argument
ioctl: VIDIOC_OVERLAY(int=1): Invalid argument
ioctl: VIDIOC_OVERLAY(int=1): Invalid argument

when I try tvtime, all I get is a blue screen that says no signal.

I think the driver is loading because I can see these messages:

bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI interrupt 0000:00:0a.0[A]: no GSI - using IRQ 10
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 10, latency: 32, mmio: 0xeb001000
bttv0: detected: AVerMedia TVCapture 98 [card=13], PCI subsystem ID is
1461:0004bttv0: using: AVerMedia TVCapture 98 [card=13,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00fff7c3 [init]
bttv0: Hauppauge/Voodoo msp34xx: reset line init [11]
bttv0: Avermedia eeprom[0x4002]: tuner=2 radio:no remote control:no
bttv0: using tuner=2
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for MSP34xx (alternate address) @ 0x88... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
tuner: chip found at addr 0xc2 i2c-bus bt878 #0 [sw]
tuner: type set to 2 (Philips NTSC (FI1236,FM1236 and compatibles)) by
bt878 #0 [sw]
bttv0: registered device video0
bttv0: registered device vbi0

I am running hoary, What am I missing  ?

-Thanks
Steve More