rtl8187

[Oleg A. Anisimov]

Что-то я не увидел сообщений о подгружаемом firmware

18 марта 2011 г. 12:38 пользователь Shinto Volokos <a.volokos на gmail.com>написал:

> Сделал, ничего интересного:
> [74284.016870] rtl8187: wireless radio switch turned off
> [74289.008912] rtl8187: wireless radio switch turned on
> [74292.973972] ADDRCONF(NETDEV_UP): wlan0: link is not ready
> [74305.493828] wlan0: authenticate with 00:1c:f0:0e:fb:b7 (try 1)
> [74305.550602] wlan0: authenticated
> [74305.617330] wlan0: associate with 00:1c:f0:0e:fb:b7 (try 1)
> [74305.684088] usb 5-1: USB disconnect, address 4
> [74305.691077] wlan0: RX AssocResp from 00:1c:f0:0e:fb:b7 (capab=0x411
> status=0 aid=1)
> [74305.691082] wlan0: associated
> [74305.765634] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
> [74316.272032] wlan0: no IPv6 routers present
> [74547.778643] usbcore: deregistering interface driver rtl8187
> [74547.857369] wlan0: deauthenticating from 00:1c:f0:0e:fb:b7 by local
> choice (reason=3)
> [74548.017133] cfg80211: All devices are disconnected, going to restore
> regulatory settings
> [74548.017140] cfg80211: Restoring regulatory settings
> [74548.017145] cfg80211: Calling CRDA to update world regulatory domain
> [74548.136078] usb 1-2: reset high speed USB device using ehci_hcd and
> address 2
> [74548.489750] cfg80211: World regulatory domain updated:
> [74548.489756]     (start_freq - end_freq @ bandwidth),
> (max_antenna_gain, max_eirp)
> [74548.489761]     (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi,
> 2000 mBm)
> [74548.489766]     (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi,
> 2000 mBm)
> [74548.489770]     (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi,
> 2000 mBm)
> [74548.489774]     (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi,
> 2000 mBm)
> [74548.489778]     (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi,
> 2000 mBm)
> [74559.018205] phy6: Selected rate control algorithm 'minstrel'
> [74559.020715] phy6: hwaddr 00:16:44:6e:6e:0f, RTL8187BvE V0 +
> rtl8225z2, rfkill mask 2
> [74559.062414] rtl8187: Customer ID is 0x00
> [74559.062483] Registered led device: rtl8187-phy6::radio
> [74559.062515] Registered led device: rtl8187-phy6::tx
> [74559.062547] Registered led device: rtl8187-phy6::rx
> [74559.064410] rtl8187: wireless switch is on
> [74559.064467] usbcore: registered new interface driver rtl8187
> [74559.136199] phy6: eeprom reset timeout!
> [74563.089668] ADDRCONF(NETDEV_UP): wlan0: link is not ready
> [74568.637326] wlan0: authenticate with 00:1c:f0:0e:fb:b7 (try 1)
> [74568.644176] wlan0: authenticated
> [74568.644219] wlan0: associate with 00:1c:f0:0e:fb:b7 (try 1)
> [74568.647660] wlan0: RX AssocResp from 00:1c:f0:0e:fb:b7 (capab=0x411
> status=0 aid=1)
> [74568.647667] wlan0: associated
> [74568.721808] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
> [74579.328035] wlan0: no IPv6 routers present
>
> В Чт., 17/03/2011 в 20:46 +0300, Oleg A. Anisimov пишет:
> > Выгрузите модуль, загрузите снова и взгляните в вывод dmesg.
>
>
>
>
> --
> ubuntu-ru mailing list
> ubuntu-ru на lists.ubuntu.com
> https://lists.ubuntu.com/mailman/listinfo/ubuntu-ru
>



-- 
--
С наилучшими пожеланиями,
Олег Анисимов AKA Yoda
----------- следущая часть -----------
Вложение в формате HTML было извлечено…
URL: <https://lists.ubuntu.com/archives/ubuntu-ru/attachments/20110319/b460bd4b/attachment-0001.html>