gegevens van harde schijf naar usb-geheugenstaaf geblokkeerd

[Milton]

…
[   14.405446] scsi 4:0:0:0: Direct-Access     USB2.0   USB Flash Disk 
  0.00 PQ: 0 ANSI: 2
[   14.407724] sd 4:0:0:0: Attached scsi generic sg2 type 0
[   14.408550] sd 4:0:0:0: [sdb] 1007616 512-byte logical blocks: (515 
MB/492 MiB)
[   14.410053] sd 4:0:0:0: [sdb] Write Protect is off
[   14.410063] sd 4:0:0:0: [sdb] Mode Sense: 00 00 00 00
[   14.410795] sd 4:0:0:0: [sdb] Asking for cache data failed
[   14.410896] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[   14.414670] sd 4:0:0:0: [sdb] Asking for cache data failed
[   14.414779] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[   14.562131]  sdb: sdb1
[   14.567256] sd 4:0:0:0: [sdb] Asking for cache data failed
[   14.567349] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[   14.567442] sd 4:0:0:0: [sdb] Attached SCSI removable disk
[   14.802938] init: failsafe main process (533) killed by TERM signal
...
zelf wordt ik er geen wijs uit.
Milton

   Dit probleem doet zich voor op een bepaalde hardware werkend met 12.04
 >> maar nu is dat opgelost met 14.04 op dezelfde machine. Het enige
 >> probleem is dat de usb-stick na het insteken niet gelijk op het scherm
 >> wordt getoond, ook niet in de launcher. Als ik echter de computer
 >> opstart met de usb-stick al aangesloten dan staat die wel in de
 >> launcher en kan ik daarop klikken.
 >> Milton
 >>
 >
 > Als je de USB-stick in de computer stopt, wordt deze dan wel herkent?
 > Dit kan je controleren met het commando "dmesg" Bij mij staat er:
 > ...
 > [ 3862.361589] usb 1-1.6: new high-speed USB device number 8 using 
ehci-pci
 > [ 3862.456328] usb 1-1.6: New USB device found, idVendor=0930,
 > idProduct=6544
 > [ 3862.456334] usb 1-1.6: New USB device strings: Mfr=1, Product=2,
 > SerialNumber=3
 > [ 3862.456338] usb 1-1.6: Product: USB Flash Memory
 > [ 3862.456341] usb 1-1.6: Manufacturer:
 > [ 3862.456344] usb 1-1.6: SerialNumber: 001D92AD676CC96193490C72
 > [ 3863.027978] usb-storage 1-1.6:1.0: USB Mass Storage device detected
 > [ 3863.028241] scsi10 : usb-storage 1-1.6:1.0
 > [ 3863.028385] usbcore: registered new interface driver usb-storage
 > [ 3864.026657] scsi 10:0:0:0: Direct-Access              USB Flash
 > Memory 1.00 PQ: 0 ANSI: 2
 > [ 3864.028632] sd 10:0:0:0: [sde] 15654848 512-byte logical blocks:
 > (8.01 GB/7.46 GiB)
 > [ 3864.029321] sd 10:0:0:0: [sde] Write Protect is off
 > [ 3864.029327] sd 10:0:0:0: [sde] Mode Sense: 65 44 09 30
 > [ 3864.030109] sd 10:0:0:0: [sde] No Caching mode page found
 > [ 3864.030116] sd 10:0:0:0: [sde] Assuming drive cache: write through
 > [ 3864.033697] sd 10:0:0:0: [sde] No Caching mode page found
 > [ 3864.033703] sd 10:0:0:0: [sde] Assuming drive cache: write through
 > [ 3864.034465]  sde: sde1 sde2
 > [ 3864.037587] sd 10:0:0:0: [sde] No Caching mode page found
 > [ 3864.037592] sd 10:0:0:0: [sde] Assuming drive cache: write through
 > [ 3864.037596] sd 10:0:0:0: [sde] Attached SCSI removable disk
 > [ 3865.106108] ISO 9660 Extensions: RRIP_1991A
 > ...
 > Als dat het geval is, dan moeten we de oplossing zoeken in udev.
 > Dit programma regelt dat na het insteken/ veranderen van hardware deze
 > netjes wordt aangekoppeld/ gebruikt.
 >
 > succes,
 >
 > floris
 >