[ubuntu-it] ho ancora problemi con la rete...

[Bruno Aleci]

tux1975 15/12/2005 22.31:
> Pietro Leone ha scritto:
>>
> 
> -----------------------OUTPUT DI IFCONFIG-------------------------------
> $ sudo ifconfig
> 
> eth0      Link encap:Ethernet  HWaddr 00:30:4F:2E:CC:F5
>           inet addr:192.168.1.104  Bcast:192.168.1.255  Mask:255.255.255.0
>           inet6 addr: fe80::230:4fff:fe2e:ccf5/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>           Interrupt:11 Base address:0xa000
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           inet6 addr: ::1/128 Scope:Host
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:194 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:194 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:15912 (15.5 KiB)  TX bytes:15912 (15.5 KiB)
> 
> non so se il modulo del kernel sia installato (ho il kernel di default
> di ubuntu 5.10 breezy, per� credo di s�, infatti posso pingare me stesso:
che modello è la scheda ethernet?
puoi fare un sudo lsmod  e mandare l'output
> 
> nota che ho anche cercato la tabella di routing, in slackware e in
> ubuntu. seguono output:
> 
> --------------------------------SLACKWARE--------------------------------
> #route
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> 192.168.1.0     *               255.255.255.0   U     0      0        0
> eth0
> loopback        *               255.0.0.0       U     0      0        0 lo
> default         192.168.1.1     0.0.0.0         UG    0      0        0
> eth0
> 
> 
> --------------------------------UBUNTU--------------------------------
> $ sudo route
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface
> localnet        *               255.255.255.0   U     0      0        0
> eth0
> default         192.168.1.1     0.0.0.0         UG    0      0        0
> eth0
> 

puoi scrivere l'output del file /etc/network/interfaces