<div dir="ltr"><div><div><div><div><div><div>Hi all,<br></div>what are the significance of increasing numbers in left of lines of output of dmesg?<br><br></div>few sample lines are here<br>[27492.199824] tg3 0000:07:00.0: >eth0: Flow control is off for TX and off for RX<br>

[27492.200229] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready<br>[33766.669509] tg3 0000:07:00.0: >eth0: Link is down<br>[33773.929450] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready<br>[33795.782122] tg3 0000:07:00.0: >eth0: Link is up at 10 Mbps, full duplex<br>

[33795.782127] tg3 0000:07:00.0: >eth0: Flow control is off for TX and off for RX<br>[33795.782363] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready<br><br></div>and what are these device addresses numbers in left of lines of output of lspci?<br>

<br><br></div>sample output <br>00:1f.6 Signal processing controller: Intel Corporation 82801I (ICH9 Family) Thermal Subsystem (rev 03)<br>04:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g LP-PHY (rev 01)<br>

07:00.0 Ethernet controller: Broadcom Corporation NetLink BCM5906M Fast Ethernet PCI Express (rev 02)<br><br></div>what are these addresses(left most numbers)?<br><br></div>thank you</div>