<div class="gmail_quote"><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">This is the command you should run, once the b43-fwcutter package is installed.<br>

&#39;b43-fwcutter -w /lib/firmware wl_apsta-3.130.20.0.o&#39; (Replace .o<br>
filename appropriately)</blockquote><div><br><b>Dear Onkar</b>, the b43-fwcutter package installed this time, after I skipped the option to <br>fetch firmware. then I ran this command, and it identified the wl_apsta file but said<br>
in the end that &quot;failed to create output directory: Permission denied&quot;. <br>&nbsp;</div><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
You can check output of command &#39;dmesg&#39; after few minutes to check if<br>
firmware got loaded. If it doesn&#39;t then restart the machine.</blockquote><div><br>I didn&#39;t wait much but running dmesg gave the info that &quot;Firmware file b43/ucode5.fw<br>not found or load failed.&quot; It suggested that I use Version 4 from <a href="http://www.linuxwireless.org/en/users/Drivers/b43#devicefirmware">http://www.linuxwireless.org/en/users/Drivers/b43#devicefirmware</a><br>
Now I am looking at this section on the page, but I can&#39;t decide how to move<br>forward. There are so many versions of the same procedure. Can you help? <br>Perhaps I just need the right firmware version. How do I identify and what<br>
is the command? <br><br>Also, I&#39;m not able to understand this line: &quot;<i>Note that you must adjust the FIRMWARE_INSTALL_DIR path to your
distribution. The standard place where firmware is installed to is
/lib/firmware</i>.&quot;<br><br>(I tried restarting also, but no luck with wifi yet.)&nbsp;</div></div><br>------- -.-<br>1/f ))) --.<br>------- ...<br><a href="http://www.algomantra.com">http://www.algomantra.com</a>