UEC installer status

[Matt Zimmerman]

On Fri, Sep 25, 2009 at 12:50:49AM -0700, Daniel Nurmi wrote:
> On Fri, Sep 25, 2009 at 12:34 AM, Dustin Kirkland <kirkland at canonical.com>wrote:
> 
> > On Thu, 2009-09-24 at 23:45 -0700, Daniel Nurmi wrote:
> > > Installed node (installation similar to above, installed correctly
> > > notified me that there was a cluster controller already running, and
> > > default selection was 'node')
> > >
> > >
> > > upon boot, the node came up, but the bridge device (and, thus,
> > > networking) did not come up
> > >      'brctl show' does not show 'br0'
> > >
> > >
> > >      eth0 exists but has no IP (dhclient is not running)
> > >
> > >
> > >      '/etc/network/interfaces' appears to have the right information
> > >      (eth0 is 'manual' and br0 is 'dhcp' with 'bridge_ports eth0'
> > >
> > >
> > >      manually running 'ifup br0' worked just fine (just doesn't work
> > > on first boot, or upon reboot)
> >
> > I didn't experience this problem.  Perhaps it's been fixed.

Dan, can you reproduce this with the current ISO?  It hasn't shown up in our
tests, so it was likely either a bug in the older build you used, or it was
affected by your network configuration.

-- 
 - mdz