[Bug 149076] Re: I can't write a cd

[dibl]

Same error, ASUS DRW-1608P3S drive, worked great in Feisty.  Kubuntu
7.10, 64-bit, generic kernel. Debug output:

K3b Version: 1.0.3

KDE Version: 3.5.8
QT Version:  3.3.7
Kernel:      2.6.22-14-generic
Devices
-----------------------
ASUS DRW-1608P3S 1.24 (/dev/scd0, ) [CD-R, CD-RW, CD-ROM, DVD-ROM, DVD-R, DVD-RW, DVD-R DL, DVD+R, DVD+RW, DVD+R DL] [DVD-ROM, DVD-R Sequential, DVD-R Dual Layer Sequential, DVD-R Dual Layer Jump, DVD-RAM, DVD-RW Restricted Overwrite, DVD-RW Sequential, DVD+RW, DVD+R, DVD+R Dual Layer, CD-ROM, CD-R, CD-RW] [SAO, TAO, RAW, SAO/R96P, SAO/R96R, RAW/R16, RAW/R96P, RAW/R96R, Restricted Overwrite, Layer Jump]

Used versions
-----------------------
cdrecord: 1.1.6

cdrecord
-----------------------
/usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.
scsidev: '/dev/scd0'
devname: '/dev/scd0'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.6
SCSI buffer size: 64512
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
TOC Type: 1 = CD-ROM
Driveropts: 'burnfree'
Device type    : Removable CD-ROM
Version        : 5
Response Format: 2
Capabilities   : 
Vendor_info    : 'ASUS    '
Identification : 'DRW-1608P3S     '
Revision       : '1.24'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009 (CD-R)
Profile: 0x002B (DVD+R/DL) 
Profile: 0x001B (DVD+R) 
Profile: 0x001A (DVD+RW) 
Profile: 0x0016 (DVD-R/DL layer jump recording) 
Profile: 0x0015 (DVD-R/DL sequential recording) 
Profile: 0x0014 (DVD-RW sequential recording) 
Profile: 0x0013 (DVD-RW restricted overwrite) 
Profile: 0x0012 (DVD-RAM) 
Profile: 0x0002 (Removable disk) 
Profile: 0x0011 (DVD-R sequential recording) 
Profile: 0x0010 (DVD-ROM) 
Profile: 0x000A (CD-RW) 
Profile: 0x0009 (CD-R) (current)
Profile: 0x0008 (CD-ROM) 
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE 
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1267712 = 1238 KB
FIFO size      : 12582912 = 12288 KB
Track 01: data   697 MB        
Total size:      800 MB (79:19.17) = 356938 sectors
Lout start:      800 MB (79:21/13) = 356938 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 5
  Is not unrestricted
  Is not erasable
  Disk sub type: Medium Type A, high Beta category (A+) (3)
  ATIP start of lead in:  -11634 (97:26/66)
  ATIP start of lead out: 359846 (79:59/71)
Disk type:    Short strategy type (Phthalocyanine or similar)
Manuf. index: 3
Manufacturer: CMC Magnetics Corporation
Blocks total: 359846 Blocks current: 359846 Blocks remaining: 2908
Starting to write CD/DVD at speed  40.0 in real SAO mode for single session.
Last chance to quit, starting real write in  2 seconds.
Speed set to 7056 KB/s
   1 seconds.
   0 seconds.
 Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Sending CUE sheet...
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB:  2A 00 FF FF FF 89 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 30 05 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0
Sense flags: Blk 0 (not valid) 
cmd finished after 21.401s timeout 200s
Writing pregap for track 1 at -150
write track pad data: error after 63488 bytes
BFree: 1000 K BSize: 1000 K
Starting new track at sector: 0
Track 01:    0 of  697 MB written.
Errno: 5 (Input/output error), write_g1 scsi sendcmd: no error
CDB:  2A 00 00 00 00 00 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 30 05 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x30 Qual 0x05 (cannot write medium - incompatible format) Fru 0x0
Sense flags: Blk 0 (not valid) 
cmd finished after 0.006s timeout 200s
/usr/bin/wodim: A write error occured.
/usr/bin/wodim: Please properly read the error message above.
write track data: error after 0 bytes
Writing  time:   41.272s
Average write speed 179.5x.
Fixating...
Fixating time:    0.101s
/usr/bin/wodim: fifo had 191 puts and 1 gets.
/usr/bin/wodim: fifo was 0 times empty and 0 times full, min fill was 100%.

cdrecord command:
-----------------------
/usr/bin/wodim -v gracetime=2 dev=/dev/scd0 speed=40 -dao driveropts=burnfree -overburn -data -tsize=356938s -

-- 
I can't write a cd
https://bugs.launchpad.net/bugs/149076
You received this bug notification because you are a member of Kubuntu
Team, which is a bug contact for k3b in ubuntu.