[PATCH 2/2][SRU][OEM-5.14] Bluetooth: btusb: Support Bluetooth Reset for Mediatek Chip(MT7921)

AceLan Kao acelan.kao at canonical.com
Fri Mar 18 02:15:26 UTC 2022


From: "mark-yw.chen" <mark-yw.chen at mediatek.com>

BugLink: https://bugs.launchpad.net/bugs/1965467

When the firmware hang or command no response, driver can reset the
bluetooth mcu via USB to recovery it. The reset steps as follows.

1. Cancel USB transfer requests before reset.
2. It use speicific USB HW Register to reset Bluetooth MCU, at the
   same time, the USB Endpoint0 still keep alive.
3. Poll the USB HW register until reset is completed by Endpoint0.
4. To recovery unexpected USB state and behavior during resetting the
   Bluetooth MCU, the driver need to reset the USB device for MT7921.
5. After the reset is completed, the Bluetooth MCU need to re-setup,
   such as download patch, power-on sequence and etc.

Signed-off-by: mark-yw.chen <mark-yw.chen at mediatek.com>
Reviewed-by: Michael Sun <michaelfsun at google.com>
Reviewed-by: Archie Pusaka <apusaka at chromium.org>
Signed-off-by: Marcel Holtmann <marcel at holtmann.org>
(cherry picked from commit e947802657cb6f540ba04f498dfd4938ed6c569e)
Signed-off-by: Chia-Lin Kao (AceLan) <acelan.kao at canonical.com>
---
 drivers/bluetooth/btusb.c | 129 ++++++++++++++++++++++++++++++++++++++
 1 file changed, 129 insertions(+)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 8e0999ba6c0c7..6363583eeba33 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -3182,6 +3182,17 @@ static int btusb_shutdown_intel_new(struct hci_dev *hdev)
 	return 0;
 }
 
+/* UHW CR mapping */
+#define MTK_BT_MISC		0x70002510
+#define MTK_BT_SUBSYS_RST	0x70002610
+#define MTK_UDMA_INT_STA_BT	0x74000024
+#define MTK_UDMA_INT_STA_BT1	0x74000308
+#define MTK_BT_WDT_STATUS	0x740003A0
+#define MTK_EP_RST_OPT		0x74011890
+#define MTK_EP_RST_IN_OUT_OPT	0x00010001
+#define MTK_BT_RST_DONE		0x00000100
+#define MTK_BT_RESET_WAIT_MS	100
+#define MTK_BT_RESET_NUM_TRIES	10
 #define FIRMWARE_MT7663		"mediatek/mt7663pr2h.bin"
 #define FIRMWARE_MT7668		"mediatek/mt7668pr2h.bin"
 
@@ -3762,6 +3773,63 @@ static int btusb_mtk_func_query(struct hci_dev *hdev)
 	return status;
 }
 
+static int btusb_mtk_uhw_reg_write(struct btusb_data *data, u32 reg, u32 val)
+{
+	struct hci_dev *hdev = data->hdev;
+	int pipe, err;
+	void *buf;
+
+	buf = kzalloc(4, GFP_KERNEL);
+	if (!buf)
+		return -ENOMEM;
+
+	put_unaligned_le32(val, buf);
+
+	pipe = usb_sndctrlpipe(data->udev, 0);
+	err = usb_control_msg(data->udev, pipe, 0x02,
+			      0x5E,
+			      reg >> 16, reg & 0xffff,
+			      buf, 4, USB_CTRL_SET_TIMEOUT);
+	if (err < 0) {
+		bt_dev_err(hdev, "Failed to write uhw reg(%d)", err);
+		goto err_free_buf;
+	}
+
+err_free_buf:
+	kfree(buf);
+
+	return err;
+}
+
+static int btusb_mtk_uhw_reg_read(struct btusb_data *data, u32 reg, u32 *val)
+{
+	struct hci_dev *hdev = data->hdev;
+	int pipe, err;
+	void *buf;
+
+	buf = kzalloc(4, GFP_KERNEL);
+	if (!buf)
+		return -ENOMEM;
+
+	pipe = usb_rcvctrlpipe(data->udev, 0);
+	err = usb_control_msg(data->udev, pipe, 0x01,
+			      0xDE,
+			      reg >> 16, reg & 0xffff,
+			      buf, 4, USB_CTRL_SET_TIMEOUT);
+	if (err < 0) {
+		bt_dev_err(hdev, "Failed to read uhw reg(%d)", err);
+		goto err_free_buf;
+	}
+
+	*val = get_unaligned_le32(buf);
+	bt_dev_dbg(hdev, "reg=%x, value=0x%08x", reg, *val);
+
+err_free_buf:
+	kfree(buf);
+
+	return err;
+}
+
 static int btusb_mtk_reg_read(struct btusb_data *data, u32 reg, u32 *val)
 {
 	int pipe, err, size = sizeof(u32);
@@ -3846,6 +3914,9 @@ static int btusb_mtk_setup(struct hci_dev *hdev)
 			return err;
 		}
 
+		/* It's Device EndPoint Reset Option Register */
+		btusb_mtk_uhw_reg_write(data, MTK_EP_RST_OPT, MTK_EP_RST_IN_OUT_OPT);
+
 		/* Enable Bluetooth protocol */
 		param = 1;
 		wmt_params.op = BTMTK_WMT_FUNC_CTRL;
@@ -3969,6 +4040,63 @@ static int btusb_mtk_shutdown(struct hci_dev *hdev)
 	return 0;
 }
 
+static void btusb_mtk_cmd_timeout(struct hci_dev *hdev)
+{
+	struct btusb_data *data = hci_get_drvdata(hdev);
+	u32 val;
+	int err, retry = 0;
+
+	/* It's MediaTek specific bluetooth reset mechanism via USB */
+	if (test_and_set_bit(BTUSB_HW_RESET_ACTIVE, &data->flags)) {
+		bt_dev_err(hdev, "last reset failed? Not resetting again");
+		return;
+	}
+
+	err = usb_autopm_get_interface(data->intf);
+	if (err < 0)
+		return;
+
+	btusb_stop_traffic(data);
+	usb_kill_anchored_urbs(&data->tx_anchor);
+
+	/* It's Device EndPoint Reset Option Register */
+	bt_dev_dbg(hdev, "Initiating reset mechanism via uhw");
+	btusb_mtk_uhw_reg_write(data, MTK_EP_RST_OPT, MTK_EP_RST_IN_OUT_OPT);
+	btusb_mtk_uhw_reg_read(data, MTK_BT_WDT_STATUS, &val);
+
+	/* Reset the bluetooth chip via USB interface. */
+	btusb_mtk_uhw_reg_write(data, MTK_BT_SUBSYS_RST, 1);
+	btusb_mtk_uhw_reg_write(data, MTK_UDMA_INT_STA_BT, 0x000000FF);
+	btusb_mtk_uhw_reg_read(data, MTK_UDMA_INT_STA_BT, &val);
+	btusb_mtk_uhw_reg_write(data, MTK_UDMA_INT_STA_BT1, 0x000000FF);
+	btusb_mtk_uhw_reg_read(data, MTK_UDMA_INT_STA_BT1, &val);
+	/* MT7921 need to delay 20ms between toggle reset bit */
+	msleep(20);
+	btusb_mtk_uhw_reg_write(data, MTK_BT_SUBSYS_RST, 0);
+	btusb_mtk_uhw_reg_read(data, MTK_BT_SUBSYS_RST, &val);
+
+	/* Poll the register until reset is completed */
+	do {
+		btusb_mtk_uhw_reg_read(data, MTK_BT_MISC, &val);
+		if (val & MTK_BT_RST_DONE) {
+			bt_dev_dbg(hdev, "Bluetooth Reset Successfully");
+			break;
+		}
+
+		bt_dev_dbg(hdev, "Polling Bluetooth Reset CR");
+		retry++;
+		msleep(MTK_BT_RESET_WAIT_MS);
+	} while (retry < MTK_BT_RESET_NUM_TRIES);
+
+	btusb_mtk_id_get(data, 0x70010200, &val);
+	if (!val)
+		bt_dev_err(hdev, "Can't get device id, subsys reset fail.");
+
+	usb_queue_reset_device(data->intf);
+
+	clear_bit(BTUSB_HW_RESET_ACTIVE, &data->flags);
+}
+
 static int btusb_recv_acl_mtk(struct hci_dev *hdev, struct sk_buff *skb)
 {
 	struct btusb_data *data = hci_get_drvdata(hdev);
@@ -4876,6 +5004,7 @@ static int btusb_probe(struct usb_interface *intf,
 		hdev->setup = btusb_mtk_setup;
 		hdev->shutdown = btusb_mtk_shutdown;
 		hdev->manufacturer = 70;
+		hdev->cmd_timeout = btusb_mtk_cmd_timeout;
 		set_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks);
 		data->recv_acl = btusb_recv_acl_mtk;
 	}
-- 
2.25.1




More information about the kernel-team mailing list