[PATCH 2/2] UBUNTU: Turn off the OMAP2_DSS_DSI support

[Stefan Bader]

On 13.08.2011 00:45, Dechesne, Nicolas wrote:
> On Fri, Aug 12, 2011 at 8:22 PM, Stefan Bader <stefan.bader at canonical.com>wrote:
> 
>> This seems to cause crashes when enabled on omap4 without
>> an SDI panel (regulator errors).
>>
>> BugLink: http://bugs.launchpad.net/bugs/720055
>>
>> Signed-off-by: Stefan Bader <stefan.bader at canonical.com>
>>
> 
> i seem to see this a bit too late... but i would have prefer to NACK this.
> this config is useful for OMAP4 boards with embedded DSI displays (such as
> TI Blaze that we intend to support with oneiric:
> http://omappedia.org/wiki/OMAP4_Blaze). i agree the name is misleading as it
> has OMAP2 in it.. in fact there was a 'break through' in the h/w arch
> between the OMAP1 familiy and the OMAP2, but OMAP3 and OMAP4 are sharing
> some IPs so some 'OMAP2' name still mean something useful on OMAP3 and
> OMAP4.
> 
> so we will need to investigate the failure and get that enabled eventually.
> we will try to reproduce and provide the proper patches.
> 

I also had hoped this one to stay in review a bit longer. Mostly because this
was something that only happened once, during an upgrade. And after DISPC going
mad in the syslog before. Just that there was this bug report that seemed to
match the one we saw quite well.
But of course, we had not the whole picture of supported boards. So Paolo, feel
free to get this enabled again.

-Stefan