[Bug 594866] Re: [Maverick][2.6.35] RT2860 (ralink) broken with rt2800pci

[Simão]

I have the same problem.

[   10.934914] rt2800pci 0000:04:06.0: PCI INT A -> GSI 21 (level, low) -> IRQ 21
[   11.035987] phy0: Selected rate control algorithm 'minstrel'
[   11.036475] Registered led device: rt2800pci-phy0::radio
[   11.036488] Registered led device: rt2800pci-phy0::assoc
[   11.036501] Registered led device: rt2800pci-phy0::quality

[   11.932183] phy0 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware
[   11.990860] ADDRCONF(NETDEV_UP): wlan0: link is not ready

My card is d-link dwa 525 and has ralink RT2860 chip.

lspci -vv

04:06.0 Network controller: RaLink Device 3060
	Subsystem: D-Link System Inc Device 3c04
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
	Latency: 32 (500ns min, 1000ns max), Cache Line Size: 64 bytes
	Interrupt: pin A routed to IRQ 21
	Region 0: Memory at fb100000 (32-bit, non-prefetchable) [size=64K]
	Capabilities: [40] Power Management version 3
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
	Kernel driver in use: rt2800pci
	Kernel modules: rt2800pci

-- 
[Maverick][2.6.35] RT2860 (ralink) broken with rt2800pci
https://bugs.launchpad.net/bugs/594866
You received this bug notification because you are a member of Kernel
Bugs, which is subscribed to linux in ubuntu.