[Bug 608279] Re: i2c support for edid on armel
Mathieu Poirier
608279 at bugs.launchpad.net
Fri Aug 20 20:20:39 UTC 2010
parse-edid demands binary date, something i2cdump doesn't provide.
I added an additional 'i2c_board_info' structure and tied it to the i2c
'eeprom' driver, which creates the following
/sys/bus/i2c/devices/3-0050/eeprom entry. From there using 'decode-
edid' specifying to scan bus 3 is trivial. Note that decode-edid calls
parse-edid.
mpoirier at beagle:~$ sudo modprobe eeprom
mpoirier at beagle:~$ decode-edid 3
decode-edid: decode-edid version 1.1
parse-edid: parse-edid version 2.0.0
parse-edid: EDID checksum passed.
# EDID version 1 revision 3
Section "Monitor"
# Block type: 2:0 3:ff
# Block type: 2:0 3:fc
Identifier "DELL P2310H"
VendorName "DEL"
ModelName "DELL P2310H"
# Block type: 2:0 3:ff
# Block type: 2:0 3:fc
# Block type: 2:0 3:fd
HorizSync 30-83
VertRefresh 56-76
# Max dot clock (video bandwidth) 170 MHz
# DPMS capabilities: Active off:yes Suspend:no Standby:no
Mode "1920x1080" # vfreq 60.000Hz, hfreq 67.500kHz
DotClock 148.500000
HTimings 1920 2008 2052 2200
VTimings 1080 1084 1089 1125
Flags "+HSync" "+VSync"
EndMode
# Block type: 2:0 3:ff
# Block type: 2:0 3:fc
# Block type: 2:0 3:fd
EndSection
mpoirier at beagle:~$
--
i2c support for edid on armel
https://bugs.launchpad.net/bugs/608279
You received this bug notification because you are a member of Kernel
Bugs, which is subscribed to linux in ubuntu.
More information about the kernel-bugs
mailing list