[Bug 269253] Re: ath5k with AR5424 fails at startup or resume
beefcurry
jonzwong at gmail.com
Sat Jun 6 14:43:44 UTC 2009
I must add that sometimes the driver stops working when in use, unless I
do a cold boot up startup fails.
Dmesg below, it first connects fine.
[ 44.728166] wlan0: authenticate with AP dd54d6b8
[ 44.730102] wlan0: authenticated
[ 44.730112] wlan0: associate with AP dd54d6b8
[ 44.732690] wlan0: RX AssocResp from ddea208a (capab=0x411 status=0 aid=3)
[ 44.732698] wlan0: associated
[ 44.734002] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 49.024268] padlock: VIA PadLock not detected.
[ 55.552096] wlan0: no IPv6 routers present
Then randomly the noise floor calibration timeout comes out again.
[ 3248.388713] ath5k phy0: noise floor calibration timeout (2437MHz)
[ 3251.716108] wlan0: beacon loss from AP dd54d6b8 - sending probe request
[ 3253.716101] wlan0: no probe response from AP dd54d6b8 - disassociating
[ 3253.881885] ath5k phy0: failed to wakeup the MAC Chip
[ 3253.881903] ath5k phy0: can't reset hardware (-5)
[ 3253.919659] ath5k phy0: failed to wakeup the MAC Chip
[ 3253.919672] ath5k phy0: can't reset hardware (-5)
[ 3253.957420] ath5k phy0: failed to wakeup the MAC Chip
[ 3253.957433] ath5k phy0: can't reset hardware (-5)
[ 3253.995263] ath5k phy0: failed to wakeup the MAC Chip
[ 3253.995274] ath5k phy0: can't reset hardware (-5)
[ 3254.033040] ath5k phy0: failed to wakeup the MAC Chip
[ 3254.033059] ath5k phy0: can't reset hardware (-5)
--
ath5k with AR5424 fails at startup or resume
https://bugs.launchpad.net/bugs/269253
You received this bug notification because you are a member of Kernel
Bugs, which is subscribed to Linux.
More information about the kernel-bugs
mailing list