[Bug 39862] Re: [Flight 6] Marvell ethernet interface doesn' t work after reboot

[Greg Taylor]

This has not resolved the issue for my Toshiba Tecra A4 with a Marvell
Yukon Gigabite network card. I am still unable to pull an IP at install.
Dmesg looks good, but I just can't get an IP. This is not a network
issue, I can immediately grab an IP on my other Dapper daily test setup.

sky2 eth0: enabling interface
sky2 eth0: Link is up at 100 Mbps, full duplex, flow control none

But I did find this earlier in the output:

sky2 v1.1 addr 0xbc000000 irq 11 Yukon-EC (0xb6) rev 1
sky 2 eth0: addr <my MAC address>
sky2 0000:02:00.0: No interrupt was generated using MSI, switching to INTx mode. Please report this failure to th PCI maintainer and include system chipset information.

-- 
[Flight 6] Marvell ethernet interface doesn' t work after reboot
https://launchpad.net/bugs/39862