[Bug 45162] Wrong acx111 PCI default firmware for DWL-G520+

[Johqn]

Public bug reported:

I use Dapper Drake Flight7

The /lib/firmware/2.6.15-21-386/acx/readme.txt indicates the acx111 PCI
default firmware is set to the "2.3.1.31" version.

But this version doesn't work properly with this card :
I can't scan my WirelessAccesssPoint (Even if the device is well detected and activated in 'network-admin').

Looking at acx100.sourceforge.net, I found that the lastest version
working properly with this device is the "1.2.0.30"

So I resolve the problem this way :
sudo rmmod acx;
sudo modprobe acx firmware=1.2.0.30;

But it would be greater if the good firmware was loaded automaticaly at
boot time.

Thanks for care.

------------------------------
lspci -vv output :
------------------------------
 Network controller: Texas Instruments ACX 111 54Mbps Wireless Interface
        Subsystem: D-Link System Inc DWL-G520+ Wireless PCI Adapter
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 32, Cache Line Size: 0x08 (32 bytes)
        Interrupt: pin A routed to IRQ 209
        Region 0: Memory at e0040000 (32-bit, non-prefetchable) [size=8K]
        Region 1: Memory at e0020000 (32-bit, non-prefetchable) [size=128K]
        Capabilities: [40] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
---------------------------------

** Affects: linux-source-2.6.15 (Ubuntu)
       Severity: Normal
       Priority: (none set)
         Status: Unconfirmed

-- 
Wrong acx111 PCI default firmware for DWL-G520+
https://launchpad.net/bugs/45162