[Bug 7592] ahc_dv_0 takes 100% CPU upon boot

bugzilla-daemon at bugzilla.ubuntu.com bugzilla-daemon at bugzilla.ubuntu.com
Tue Mar 22 06:33:53 UTC 2005


Please do not reply to this email.  You can add comments at
http://bugzilla.ubuntu.com/show_bug.cgi?id=7592
Ubuntu | linux





------- Additional Comments From sapienguard-ubuntu at yahoo.com  2005-03-22 06:33 UTC -------
My dmesg shows "DV failed to configure device" (see below) which may be related
to ahc_dv_0 taking 100% on startup. I haven't tried another distribution with
this disk (but the original poster did). 

<OFFTOPIC> It looks like I fixed an unrelated problem with system lockup by
upgrading the disk firmware to the latest version. </OFFTOPIC>

scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
        <Adaptec 29160 Ultra160 SCSI adapter>
        aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs

(scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 127, 16bit)
scsi0:A:1:0: DV failed to configure device.  Please file a bug report against
this driver.
  Vendor: IBM-ESXS  Model: DTN036W3UWDY10FN  Rev: S29C
  Type:   Direct-Access                      ANSI SCSI revision: 03
scsi0:A:0:0: Tagged Queuing enabled.  Depth 8

-- 
Configure bugmail: http://bugzilla.ubuntu.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug, or are watching the QA contact.




More information about the kernel-bugs mailing list