[Bug 20498] prism2_usb does not work any more in 2.6.15
bugzilla-daemon at bugzilla.ubuntu.com
bugzilla-daemon at bugzilla.ubuntu.com
Fri Dec 16 16:58:31 UTC 2005
Please do not reply to this email. You can add comments at
http://bugzilla.ubuntu.com/show_bug.cgi?id=20498
Ubuntu | linux
------- Additional Comments From martin.pitt at ubuntu.com 2005-12-16 16:58 UTC -------
For comparing, the old 2.6.12 kernel shows the following messages (after
manually modprobing prism2_usb due to new udev world order):
[ 92.696629] usb 2-1: new full speed USB device using ohci_hcd and address 2
[ 108.270947] prism2usb_init: prism2_usb.o: 0.2.2 Loaded
[ 108.270967] prism2usb_init: dev_info is: prism2_usb
[ 108.398898] usbcore: registered new driver prism2_usb
[ 108.844506] PDA Read from 0x007f0000 in EXTDS space.
[ 108.855510] PDA Read from 0x007f0000 in EXTDS space.
There are some further messages that appear after ifup'ing the device, I'll
attach the full dmesg output again.
With 2.6.12, the iwconfig output is correct:
wlan0 IEEE 802.11-DS ESSID:"www.fbn-dd.de (WER)" Nickname:"www.fbn-dd.de
(WER)"
Mode:Managed Frequency:2.412 GHz Access Point: 00:02:2D:3B:BF:35
Bit Rate:2 Mb/s Tx-Power:18 dBm
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Link Quality=3/92 Signal level=-85 dBm Noise level=-89 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
(I do not actually get a signal at the place I tested this at, so the missing
signal is correct).
--
Configure bugmail: http://bugzilla.ubuntu.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug, or are watching the QA contact.
More information about the kernel-bugs
mailing list