Problem with editing file on container

Tom Barber tom at
Sat Dec 9 21:06:12 UTC 2017

You should be able run

export TERM=xterm

or similar and then open the editor.


On 09/12/17 18:59, Naas Si Ahmed wrote:
> Hi,
> I'm trying to modify a file using the command vi or nano to edit a 
> file on a juju container, but I'm receiving an error such : terminal 
> unknown.
> Is there any way that I can use to edit a file graphically from 
> another juju container ?
> The juju command I used is :
> Juju run "vi /etc/conf.rules" --machine =8
> Thank you,
> Ahmed.


Spicule Limited is registered in England & Wales. Company Number: 09954122. 
Registered office: First Floor, Telecom House, 125-135 Preston Road, 
Brighton, England, BN1 6AF. VAT No. 251478891.

All engagements are subject to Spicule Terms and Conditions of Business. 
This email and its contents are intended solely for the individual to whom 
it is addressed and may contain information that is confidential, 
privileged or otherwise protected from disclosure, distributing or copying. 
Any views or opinions presented in this email are solely those of the 
author and do not necessarily represent those of Spicule Limited. The 
company accepts no liability for any damage caused by any virus transmitted 
by this email. If you have received this message in error, please notify us 
immediately by reply email before deleting it from your system. Service of 
legal notice cannot be effected on Spicule Limited by email.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <>

More information about the Juju mailing list