[Bug 15373] gdm loads slowly

[bugzilla-daemon at bugzilla.ubuntu.com]

Please do not reply to this email.  You can add comments at
http://bugzilla.ubuntu.com/show_bug.cgi?id=15373
Ubuntu | gdm





------- Additional Comments From scottraynel at gmail.com  2005-09-14 01:27 UTC -------
(In reply to comment #0)
> I'm running Ubuntu Breezy, and has been updated today. However gdm is still
> loading slow for me, it takes ~2 seconds to load the graphic, and loads it
> diagonally and jagged -- it doesn't look very nice. Hoary on the other hand
> loads gdm instantly on the same machine.

Same here. I'm on a Dell Inspiron 510m Laptop. Here is lspci -vv for me:

0000:00:02.0 VGA compatible controller: Intel Corp. 82852/855GM Integrated
Graphics Device (rev 02) (prog-if 00 [VGA])
        Subsystem: Dell: Unknown device 0164
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at f0000000 (32-bit, prefetchable) [size=128M]
        Region 1: Memory at faf80000 (32-bit, non-prefetchable) [size=512K]
        Region 2: I/O ports at c000 [size=8]
        Capabilities: [d0] Power Management version 1
                Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

0000:00:02.1 Display controller: Intel Corp. 82852/855GM Integrated Graphics
Device (rev 02)
        Subsystem: Dell: Unknown device 0164
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
        Latency: 0
        Region 0: Memory at e8000000 (32-bit, prefetchable) [size=128M]
        Region 1: Memory at faf00000 (32-bit, non-prefetchable) [size=512K]
        Capabilities: [d0] Power Management version 1
                Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I'm using the i810 driver, which was detected by the installer.

Cheers.

-- 
Configure bugmail: http://bugzilla.ubuntu.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug, or are watching the QA contact.