[ubuntu/bionic-proposed] linux-oem 4.15.0-1005.8 (Accepted)

Łukasz Zemczak lukasz.zemczak at canonical.com
Mon May 14 11:09:18 UTC 2018

linux-oem (4.15.0-1005.8) bionic; urgency=medium

  * linux-oem: 4.15.0-1005.8 -proposed tracker (LP: #1767398)
    - source built with a clean tree

  * [i915 CNL-Y] system hangs soon after bootup (LP: #1769843)
    - SAUCE: drm/i915/execlists: Use rmb() to order CSB reads

  * hts221 sensor stops working after resume from S3/S4 (LP: #1769658)
    - SAUCE: iio: humidity: hts221: Fix sensor reads after resume

  * Support Intel Atom (Baytrail-I) HS-UART serdev slaves over tty
    (LP: #1769610)
    - serdev: ttyport: release tty lock sooner on open
    - serdev: ttyport: ignore carrier detect to avoid hangups
    - serdev: ttyport: do not used keyed wakeup in write_wakeup
    - serdev: Make .remove in struct serdev_device_driver optional
    - serdev: Introduce devm_serdev_device_open()
    - serdev: do not generate modaliases for controllers
    - serdev: only match serdev devices
    - serdev: add method to set parity
    - SAUCE: (no-up) Support HS-UART serdev slaves over tty

  * Support latest Redpine WLAN/BT RS9113 driver (LP: #1657682)
    - SAUCE: rsi: add rx control block to handle rx packets in USB
    - SAUCE: rsi: add bluetooth rx endpoint
    - SAUCE: rsi: add header file rsi_91x
    - SAUCE: rsi: add coex support
    - SAUCE: Bluetooth: bt: rsi: add new rsi bluetooth driver
    - SAUCE: rsi: handle BT traffic in driver
    - SAUCE: rsi: add module parameter operating mode
    - SAUCE: rsi: sdio changes to support BT
    - SAUCE: rsi: improve RX handling in SDIO interface
    - SAUCE: rsi: use dynamic RX control blocks instead of MAX_RX_URB
    - SAUCE: rsi: improve RX packet handling in USB interface
    - SAUCE: rsi: add support for hardware scan offload
    - SAUCE: rsi: move xtend_desc structure from rsi_main.h to rsi_mgmt.h
    - SAUCE: rsi: move descriptor preparation to core
    - SAUCE: rsi: enable 80MHz clock by default
    - SAUCE: rsi: roaming enhancements
    - SAUCE: rsi: add module parameter rsi_reg
    - SAUCE: rsi: regulatory modifications for 'dlcar' mode
    - SAUCE: rsi: device disconnect changes
    - SAUCE: rsi: tx improvements
    - SAUCE: rsi: drop RX broadcast/multicast packets with invalid PN
    - SAUCE: rsi: fix for incorrect data pointer alignment in 64-bit
    - SAUCE: rsi: Remove stack VLA usage
    - SAUCE: rsi: fix nommu_map_sg overflow kernel panic
    - SAUCE: rsi: Fix 'invalid vdd' warning in mmc
    - SAUCE: Redpine: Fix wowlan issue with S4
    - SAUCE: Redpine: rsi: Add deep sleep enable before connection
    - SAUCE: Redpine: resolve power save issue after S4 resume
    - SAUCE: Redpine: rsi: resolve wifi scan stop issue in stress tests
    - SAUCE: rsi: Firmware assert
    - SAUCE: Added fix for connection issue observed with nmcli command.
    - SAUCE: Added fix for hang issue observed during hibernate resume.
    - SAUCE: Added fix for issue power off when connected to AP through nmcli.
    - SAUCE: rsi: improve cancel_hw_scan handling to fix kernel panic
    - [Config]: CONFIG_BT_HCIRSI=m

  * Support latest Redpine WLAN/BT RS9113 driver (LP: #1657682) // INVALID or
    PRIVATE BUG (LP: #1736097) // INVALID or PRIVATE BUG (LP: #1738169)
    - SAUCE: Redpine: fix wowlan issue
    - SAUCE: Redpine: fix reset card issue
    - SAUCE: Redpine: fix for wowlan wakeup failure

  * Support latest Redpine WLAN/BT RS9113 driver (LP: #1657682) // ubuntu/rsi
    driver downlink wifi throughput drops to 5-6 Mbps when BT keyboard is
    connected (LP: #1706991)
    - SAUCE: Redpine: uapsd configuration changes

  * Miscellaneous Ubuntu changes
    - Rebase to 4.15.0-21.22
    - [Config] update configs following rebase to 4.15.0-21.22

  [ Ubuntu: 4.15.0-21.22 ]

  * linux: 4.15.0-21.22 -proposed tracker (LP: #1767397)
  * initramfs-tools exception during pm.DoInstall with  do-release-upgrade from
    16.04 to 18.04  (LP: #1766727)
    - Add linux-image-* Breaks on s390-tools (<< 2.3.0-0ubuntu3)
  * linux-image-4.15.0-20-generic install after upgrade from xenial breaks
    (LP: #1767133)
    - Packaging: Depends on linux-base that provides the necessary tools
  * linux-image packages need to Breaks flash-kernel << 3.90ubuntu2
    (LP: #1766629)
    - linux-image-* breaks on flash-kernel (<< 3.90ubuntu2)

Date: 2018-05-10 11:09:15.064517+00:00
Changed-By: Timo Aaltonen <tjaalton at ubuntu.com>
Signed-By: Łukasz Zemczak <lukasz.zemczak at canonical.com>
-------------- next part --------------
Sorry, changesfile not available.

More information about the Bionic-changes mailing list